Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Front Side)

WASHER NOZZLE (for Front Side) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WASHER NOZZLE SUB-ASSEMBLY


  1. With the engine running, check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E214571E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    A
    95.8 mm (3.77 in.)
    B
    323.6 mm (1.06 ft.)
    C
    161.4 mm (6.35 in.)
    D
    155.7 mm (6.13 in.)
    E
    443.7 mm (1.46 ft.)
    F
    546.6 mm (1.79 ft.)
    G
    208.2 mm (8.20 in.)
    H
    82.1 mm (3.23 in.)

    Text in Illustration 
    *1
    Upper Limit
    *2
    Standard
    *3
    Lower Limit
    -
    -

    HINT:
    If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.