Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR

RAIN SENSOR > REMOVAL

for Preparation Click here



1. REMOVE RAIN SENSOR COVER


    E189311
  1. Disconnect the rain sensor cover as shown in the illustration.

  1. Disengage the 2 claws and remove the rain sensor cover.



2. REMOVE RAIN SENSOR


    E189314
  1. Disconnect the connector.



    E189312E01
  1. Release the stopper by pulling the stopper down and disconnect the rain sensor as shown in the illustration.
    Text in Illustration 
    *1
    Stopper



3. CLEAN WINDSHIELD GLASS

NOTICE:
  1. The rain sensor tape can be reused, however, replace it with a new one if it has dirt on it or it is damaged.
  2. Check that the rain sensor tape does not remain on the windshield glass. If it does, remove it before installing the rain sensor.