Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)


  1. Disconnect the main body ECU (multiplex network body ECU) connectors.


    B230102E04

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L7-6 (LRCY) - Body ground
    G - Body ground
    Rear courtesy light switch LH and RH input
    Rear door LH and RH closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    A-2 (FLCY) - Body ground
    -
    Front left door courtesy light switch input
    Front left door closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    A-4 (FRCY) - Body ground
    -
    Front right door courtesy light switch input
    Front right door closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    L7-19 (BCTY) - Body ground
    L - Body ground
    Back door courtesy light switch input
    Back door closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    A-29 (ACC) - Body ground
    -
    Ignition power supply (ACC signal)
    Power switch on (ACC) → off
    11 to 14 V → Below 1 V
    A-31 (ALTB) - Body ground
    -
    +B (power system alternator system) power supply
    Power switch off
    11 to 14 V
    A-32 (IG) - Body ground
    -
    Ignition power supply (IG signal)
    Power switch on (IG) → off
    11 to 14 V → Below 1 V
    A-11 (GND1) - Body ground
    -
    Ground
    Always
    Below 1 Ω
    L8-3 (GND2) - Body ground*
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    *: w/ Intrusion Sensor

    HINT:
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the main body ECU (multiplex network body ECU) connectors.

  4. Measure the voltage and resistance according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L8-8 (SSW1) - Body ground*1
    G - Body ground
    Intrusion sensor cancel switch signal
    Intrusion sensor cancel switch on
    Below 1 V
    L8-8 (SSW1) - Body ground*1
    G - Body ground
    Intrusion sensor cancel switch signal
    Intrusion sensor cancel switch off
    Pulse generation
    L8-12 (ISIF) - Body ground*1
    V - Body ground
    Theft warning radar sensor (intrusion sensor) signal input
    No moving object detected by sensor
    11 to 14 V
    L8-12 (ISIF) - Body ground*1
    V - Body ground
    Theft warning radar sensor (intrusion sensor) signal input
    Moving object detected by sensor during arming preparation state or armed state
    Pulse generation
    L7-3 (HAZ) - Body ground
    Y - Body ground
    Turn signal flasher relay signal
    System in alarm sounding state
    Below 1 V
    L8-18 (SSCL)*1 - Body ground
    L - Body ground
    Theft warning siren drive
    Theft warning siren sounding
    (Theft deterrent system is in alarm sounding state)
    Pulse generation
    (Below 1 V ← → 12 V)
    A-19 (GPBS) - Body ground*1
    -
    Glass breakage sensor drive
    Always (Back door glass and back window fix glass not broken)
    Below 1 V
    A-28 (HORN) - Body ground
    -
    Vehicle horn drive
    Vehicle horns sounding
    (Theft deterrent system is in alarm sounding state)
    Pulse generation
    (Below 1 V ← → 12 V)
    A-17 (SH)*2 - Body ground
    -
    Security horn drive
    Security horn sounding
    (Theft deterrent system is in alarm sounding state)
    Pulse generation
    (Below 1 V ← → 12 V)
    A-20 (HCTY) - Body ground
    -
    Engine courtesy switch input
    Engine hood open (ON) → closed (OFF)
    Below 1 Ω → 10 kΩ or higher
    A-23 (IND) - Body ground
    -
    Security indicator light up
    Security indicator light on (It lights up only for 27.5 sec. in alarm sounding state.)
    3 to 6 V
    If the result is not as specified, the main body ECU (multiplex network body ECU) may have a malfunction.

    1. *1: w/ Intrusion Sensor
    2. *2: w/o Intrusion Sensor