THEFT DETERRENT SYSTEM > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Select the item below in the Active Test and then check that the indicator operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator | ON / OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Disconnect the 2A instrument panel junction block assembly and A main body ECU (multiplex network body ECU) connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2A-51 - A-25 (IND) | Always | Below 1 Ω |
| *1 | Component without harness connected (Instrument Panel Junction Block Assembly) | *2 | Front view of wire harness connector (to Main Body ECU (Multiplex Network Body ECU)) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER (SECURITY INDICATOR) - MAIN BODY ECU) |
![]() |
Disconnect the L27 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2A-51 - L27-22 (LP) | Always | Below 1 Ω |
| L27-22 (LP) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Combination Meter Assembly (Security Indicator Light)) |
| *2 | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER (SECURITY INDICATOR LIGHT) - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L27-30 (ES) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Combination Meter Assembly (Security Indicator Light)) |
|
| ||||
| OK | |
| 5.INSPECT SECURITY INDICATOR LIGHT |
![]() |
Remove the combination meter assembly with harness connected. (Click here)
Apply battery voltage from the wire harness back side between the specified terminals of the security indicator light, and check the lighting condition of the security indicator light.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal L27-22 (LP) Battery negative (-) → Terminal L27-30 (ES) | Security indicator light comes on |
| *1 | Component with harness connected (Combination Meter Assembly (Security Indicator Light)) |
|
| ||||
| OK | ||
| ||