Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › INTRUSION SENSOR

INTRUSION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ROOF TOP MOULDING


    B227832
  1. Using moulding remover B, disengage the 3 claws and 2 clips, and remove the roof top moulding.



2. REMOVE MAP LIGHT ASSEMBLY (w/o Sliding Roof)


    E189673
  1. Disengage the 4 clips and 2 guides as shown in the illustration.

  1. Disconnect the connector and remove the map light assembly.



3. REMOVE MAP LIGHT ASSEMBLY (w/ Sliding Roof)


    E189671
  1. Disengage the 4 clips and 2 guides as shown in the illustration.

  1. Disconnect the connector and remove the map light assembly.



4. REMOVE THEFT WARNING RADAR SENSOR


    B229305
  1. Disconnect the connector.

  1. Disengage the clamp.

  1. Remove the 3 screws and theft warning radar sensor.