HEADLIGHT ASSEMBLY > REMOVAL |
| 1. PRECAUTION (w/ Navigation System for HDD) |
| 2. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 3. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 4. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 6. REMOVE RADIATOR SUPPORT OPENING COVER |
![]() |
Remove the 3 clips.
Disengage the 2 claws and remove the radiator support opening cover.
| 7. REMOVE FRONT BUMPER ASSEMBLY |
![]() |
Put protective tape around the front bumper assembly.
| *1 | Protective Tape |
![]() |
Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.
![]() |
Remove the screw.
![]() |
Remove the 2 bolts and 4 screws.
Using a clip remover, remove the 7 clips.
![]() |
Using a clip remover, remove the 2 clips. (w/ Front Spoiler)
Remove the 2 screws. (w/ Front Spoiler)
Disengage the 2 guides and remove the front spoiler cover. (w/ Front Spoiler)
![]() |
Disengage the 3 claws and remove the front bumper assembly.
Disconnect each connector.
Disconnect the headlight cleaner hose and drain the washer fluid. (w/ Headlight Cleaner System)
![]() |
Remove the front bumper assembly as shown in the illustration.
| 8. REMOVE HEADLIGHT ASSEMBLY |
![]() |
Remove the bolt and 2 screws.
Using a screwdriver wrapped with protective tape, disengage the claw.
| *1 | Protective Tape |
![]() |
Disengage the clamp.
Disconnect each connector and remove the headlight assembly.