Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE REAR NO. 2 FLOOR BOARD


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. REMOVE RADIATOR SUPPORT OPENING COVER


    B228429
  1. Remove the 3 clips.

  1. Disengage the 2 claws and remove the radiator support opening cover.



7. REMOVE FRONT BUMPER ASSEMBLY


    B228430E01
  1. Put protective tape around the front bumper assembly.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Use the same procedure for the RH side and LH side.



    B228431
  1. Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228433
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228434
  1. Remove the 2 bolts and 4 screws.

  1. Using a clip remover, remove the 7 clips.



    B228436
  1. Using a clip remover, remove the 2 clips. (w/ Front Spoiler)

  1. Remove the 2 screws. (w/ Front Spoiler)

  1. Disengage the 2 guides and remove the front spoiler cover. (w/ Front Spoiler)



    B228439
  1. Disengage the 3 claws and remove the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector.

  1. Disconnect the headlight cleaner hose and drain the washer fluid. (w/ Headlight Cleaner System)

    HINT:
    Use a container to collect the washer fluid.



    B228441
  1. Remove the front bumper assembly as shown in the illustration.



8. REMOVE HEADLIGHT ASSEMBLY


    E189577E01
  1. Remove the bolt and 2 screws.

  1. Using a screwdriver wrapped with protective tape, disengage the claw.
    Text in Illustration 
    *1
    Protective Tape



    E189579
  1. Disengage the clamp.

  1. Disconnect each connector and remove the headlight assembly.