Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REASSEMBLY

for Preparation Click here



1. INSTALL COVER RING (for LED Headlight)


    E238401
  1. Turn the cover ring in the direction indicated by the arrow shown in the illustration to install it.



2. INSTALL HEADLIGHT GASKET (for LED Headlight)
  1. Install a new headlight gasket.



3. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY (for LED Headlight)


    E238398
  1. Connect the connector.



    E238397
  1. Install the headlight light control ECU sub-assembly with the 4 screws.



4. INSTALL HEADLIGHT LEVELING MOTOR BASE PACKING (for Halogen Headlight)
  1. Install a new headlight leveling motor base packing.



5. INSTALL HEADLIGHT LEVELING MOTOR (for Halogen Headlight)


    E189591E02
  1. Insert the headlight leveling motor in the direction indicated by the arrow (1) shown in the illustration.

  1. Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (2) shown in the illustration to engage the shaft.
    Text in Illustration 
    *1
    Aiming Screw

    HINT:
    Turn the aiming screw the same number of times as it was turned during removal.



    E241054E01
  1. Turn the headlight leveling motor in the direction indicated by the arrow (3) shown in the illustration and engage the pin to install the headlight leveling motor to the headlight unit.

    HINT:
    When installing the headlight leveling motor of the headlight assembly RH, turn the headlight leveling motor in the opposite direction indicated by the arrow (3) shown in the illustration.

  1. Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (4) shown in the illustration to install it.
    Text in Illustration 
    *1
    Aiming Screw

    HINT:
    Turn the aiming screw the same number of times as it was turned during removal.



6. INSTALL HEADLIGHT CORD (for Halogen Headlight)


    E189587
  1. Engage the 2 clamps and install the headlight cord.



7. INSTALL CLEARANCE LIGHT BULB (for Halogen Headlight)
  1. Install the clearance light bulb to the headlight cord.



    E189586
  1. Turn the headlight cord with the clearance light bulb in the direction indicated by the arrow shown in the illustration and connect them as a unit.



8. INSTALL NO. 2 HEADLIGHT BULB (for Halogen Headlight)


    E189584
  1. Turn the No. 2 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.

    NOTICE:
    1. Do not touch the bulb glass.
    2. Correctly align the 3 tabs on the bulb when installing it to the headlight assembly.



9. INSTALL NO. 1 HEADLIGHT BULB


    E189582
  1. Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.

    NOTICE:
    Do not touch the bulb glass.