Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › EMISSION CONTROL SYSTEM

EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK FUEL CUT RPM
  1. Put the engine in inspection mode (Click here).

  1. Start and warm up the engine.

  1. Increase the engine speed to at least 2500 rpm.



    A215616E01
  1. Use a sound scope to check for injector operating sounds.
    Text in Illustration 
    *1
    Injector
    *2
    Sound Scope

  1. When the accelerator pedal is released, check that injector operating sounds stop momentarily (at 2500 rpm or higher) and then resume (at 1200 rpm).

    Standard:
    Item
    Specified Condition
    Fuel cut off rpm
    2500 rpm
    Fuel injection restart rpm
    1200 rpm

    If the result is not as specified, check the injectors, wiring and ECM.



2. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS


    A213091
  1. Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

    NOTICE:
    1. Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose and other components may cause the engine to run improperly.
    2. Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body and cylinder head will cause an engine failure or engine malfunction.

    If any defects are found, replace parts as necessary.



3. INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM
  1. Connect the intelligent tester to the DLC3.



    A215617
  1. Disconnect the fuel vapor feed hose from the purge valve shown in the illustration.

  1. Put the engine in inspection mode (Click here).

  1. Start the engine.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.

  1. Check that vacuum occurs at the purge valve port.

  1. If vacuum does not occur, check the following items.

    HINT:
    1. VSV (for canister purge)
    2. Clogging in the fuel vapor feed hose connecting the intake air surge tank and VSV
    3. Voltage from the ECM PRG terminal

  1. Exit Active Test mode and reconnect the fuel vapor feed hose.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.

  1. Warm up the engine and drive the vehicle.

  1. Confirm that the purge valve opens.
    If the result is not as specified, replace the purge valve, wire harness or ECM.