Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › PCV VALVE

PCV VALVE > INSTALLATION

for Preparation Click here



1. INSTALL VENTILATION VALVE SUB-ASSEMBLY


    A105280E07
  1. Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.
    Text in Illustration 
    *1
    Adhesive 1324

    Adhesive:
    Toyota genuine adhesive 1324, three bond 1324 or equivalent



    A212679E01
  1. Using a ball joint lock nut wrench (22 mm), install the ventilation valve sub-assembly.
    Text in Illustration 
    *1
    Ball Joint Lock Nut Wrench (22 mm)

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench (Click here).



    A212678
  1. Install the ventilation hose to the ventilation valve sub-assembly.



2. INSTALL NO. 1 ENGINE UNDER COVER


3. INSTALL AIR CLEANER CASE


    A212314
  1. Install the air cleaner case with the 3 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Install the hose to the 3 hose clamps.

  1. Install the air cleaner filter element.



4. INSTALL INLET AIR CLEANER ASSEMBLY


    A269507
  1. Install the inlet air cleaner assembly with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    A212312E01
  1. Install the air cleaner cap sub-assembly with the 2 clamps.

  1. Tighten the hose clamp.



    A212311
  1. Connect the mass air flow meter connector.



6. INSTALL NO. 2 CYLINDER HEAD COVER


    A213020
  1. Engage the 3 clips to install the cover.

    NOTICE:
    1. Be sure to engage the clips securely.
    2. Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.