Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › PCV VALVE

PCV VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A213020
  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    2. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A212311
  1. Disconnect the connector.



    A288960
  1. Loosen the hose clamp and disconnect the air cleaner hose assembly.

  1. Remove the 2 clamps and air cleaner cap sub-assembly.



3. REMOVE INLET AIR CLEANER ASSEMBLY


    A269507
  1. Remove the 2 bolts and inlet air cleaner assembly.



4. REMOVE AIR CLEANER CASE
  1. Remove the air cleaner filter element sub-assembly.



    A212314
  1. Separate the hose from the 3 clamps.

  1. Remove the 3 bolts and air cleaner case.



5. REMOVE NO. 1 ENGINE UNDER COVER


6. REMOVE VENTILATION VALVE SUB-ASSEMBLY


    A212678
  1. Remove the ventilation hose from the ventilation valve sub-assembly.



    A212679E01
  1. Using a ball joint lock nut wrench (22 mm), remove the ventilation valve sub-assembly.
    Text in Illustration 
    *1
    Ball Joint Lock Nut Wrench (22 mm)