ELECTRONIC SHIFT LEVER SYSTEM > DTC CHECK / CLEAR |
| CHECK FOR DTCS (Using the intelligent tester) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / Transmission Control / Trouble Codes.
Check for DTCs and freeze frame data, and then write them down.
Check the details of the DTCs.
| CHECK FOR DTCS (Systems other than the transmission control ECU) |
If DTCs are present, check the relevant systems.
| CLEAR DTCS (Using the intelligent tester) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / Transmission Control / Trouble Codes.
Clear the DTCs and freeze frame data.
| CLEAR DTCS (Without using the intelligent tester) |
Turn the power switch off.
Remove the P CON MAIN fuses from the engine room junction block assembly located inside the engine compartment for more than 1 minute.
Check for DTCs again to see if the DTCs are cleared.