Home › Vehicle Exterior › LIGHTING (EXT) › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER RELAY (DIM)


    B087894E04
  1. Remove the headlight dimmer relay from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the headlight dimmer relay.



2. INSPECT REAR FOG LIGHT RELAY


    B060778E86
  1. Remove the rear fog light relay.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the rear fog light relay.