Home › Vehicle Exterior › LIGHTING (EXT) › HIGH MOUNTED STOP LIGHT ASSEMBLY

HIGH MOUNTED STOP LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT CENTER STOP LIGHT ASSEMBLY


    E297633E02
  1. Connect a positive (+) lead from the battery to terminal 2 (B) and a negative (-) lead to terminal 1 (E).

  1. Check that the center stop light comes on.

    OK:
    The light comes on.

    Text in Illustration 
    *1
    Component without harness connected
    (Center Stop Light Assembly)
    If the result is not as specified, replace the center stop light assembly.



2. INSPECT CENTER STOP LIGHT WIRE HARNESS


    E298158E02
  1. Measure the resistance according to the value(s) in the table below.
    Standard Resistance: 
    Tester Connection
    Condition
    Specified Condition
    WT1-1 (E2) - W1-1 (E)
    Always
    Below 1 Ω
    WT1-1 (E2) - W1-2 (B)
    Always
    10 kΩ or higher
    WT1-2 (LED) - W1-1 (B)
    Always
    Below 1 Ω
    WT1-2 (LED) - W1-2 (E)
    Always
    10 kΩ or higher
    Text in Illustration 
    *1
    Component without harness connected
    (Center Stop Light Wire Harness)
    If the result is not as specified, replace the center stop light set.