CAN COMMUNICATION SYSTEM > Skid Control ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Skid Control ECU Communication Stop Mode |
|
|


| 1.CHECK DTC (BRAKE SYSTEM) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
|
| ||||
| OK | |
| 2.CHECK CAN BUS WIRE FOR DISCONNECTION (SKID CONTROL ECU BRANCH WIRE) |
Turn the power switch off.
![]() |
Disconnect the skid control ECU connector.
| *1 | Front view of wire harness connector (to Skid Control ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A58-37 (CA1H) - A58-38 (CA1L) | Power switch off | 54 to 69 Ω |
| Result | Proceed to |
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||