WIPER AND WASHER SYSTEM > Wiper and Washer Switch Circuit |

| 1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY |
![]() |
for Light Control Switch LH Side Type:
Remove the windshield wiper switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L48-3 (+1) - L48-1 (+S) | OFF | Below 1 Ω |
| L48-3 (+1) - L48-2 (+B) | MIST | |
| LO | ||
| L48-2 (+B) - L48-4 (+2) | HI | |
| L48-9 (AUTO) - L48-10 (E) | AUTO |
| Tester Connection | Switch Condition | Specified Condition |
| L49-2 (EW) - L49-3 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| L48-7 (VR1) - L48-8 (VR2) | Adjusting ring changed from (+) side to (-) side | 0 to 2.7 kΩ |
| *1 | Component without harness connected (to Windshield Wiper Switch Assembly) |
![]() |
for Light Control Switch RH Side Type:
Remove the windshield wiper switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L48-2 (+1) - L48-4 (+S) | OFF | Below 1 Ω |
| L48-2 (+1) - L48-3 (+B) | MIST | |
| LO | ||
| L48-3 (+B) - L48-1 (+2) | HI | |
| L48-6 (AUTO) - L48-5 (E) | AUTO |
| Tester Connection | Switch Condition | Specified Condition |
| L49-2 (EW) - L49-1 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| L48-8 (VR1) - L48-7 (VR2) | Adjusting ring changed from (+) side to (-) side | 0 to 2.7 kΩ |
| *1 | Component without harness connected (to Windshield Wiper Switch Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (WIPER SWITCH - WIPER RELAY AND BODY GROUND) |
for Light Control Switch LH Side Type:
Disconnect the L49 and L48 windshield wiper switch assembly connectors.
Disconnect the L114 windshield wiper relay assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L48-2 (+B) - L114-12 (IG) | Always | Below 1 Ω |
| L48-2 (+B) - Body ground | Always | 10 kΩ or higher |
| L48-3 (+1) - L114-1 (+2S) | Always | Below 1 Ω |
| L48-3 (+1) - Body ground | Always | 10 kΩ or higher |
| L48-4 (+2) - L114-3 (+2) | Always | Below 1 Ω |
| L48-4 (+2) - Body ground | Always | 10 kΩ or higher |
| L48-1 (+S) - L114-11 (+SSW) | Always | Below 1 Ω |
| L48-1 (+S) - Body ground | Always | 10 kΩ or higher |
| L48-9 (AUTO) - L114-17 (C1) | Always | Below 1 Ω |
| L48-9 (AUTO) - Body ground | Always | 10 kΩ or higher |
| L48-10 (E) - L114-16 (CO) | Always | Below 1 Ω |
| L48-10 (E) - Body ground | Always | 10 kΩ or higher |
| L48-7 (VR1) - L114-7 (VR1) | Always | Below 1 Ω |
| L48-7 (VR1) - Body ground | Always | 10 kΩ or higher |
| L48-8 (VR2) - L114-6 (VR2) | Always | Below 1 Ω |
| L48-8 (VR2) - Body ground | Always | 10 kΩ or higher |
| L49-3 (WF) - L114-4 (W) | Always | Below 1 Ω |
| L49-3 (WF) - Body ground | Always | 10 kΩ or higher |
| L49-2 (EW) - Body ground | Always | Below 1 Ω |
for Light Control Switch RH Side Type:
Disconnect the L49 and L48 windshield wiper switch assembly connectors.
Disconnect the L114 windshield wiper relay assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L48-3 (+B) - L114-12 (IG) | Always | Below 1 Ω |
| L48-3 (+B) - Body ground | Always | 10 kΩ or higher |
| L48-2 (+1) - L114-1 (+2S) | Always | Below 1 Ω |
| L48-2 (+1) - Body ground | Always | 10 kΩ or higher |
| L48-1 (+2) - L114-3 (+2) | Always | Below 1 Ω |
| L48-1 (+2) - Body ground | Always | 10 kΩ or higher |
| L48-4 (+S) - L114-11 (+SSW) | Always | Below 1 Ω |
| L48-4 (+S) - Body ground | Always | 10 kΩ or higher |
| L48-6 (AUTO) - L114-17 (C1) | Always | Below 1 Ω |
| L48-6 (AUTO) - Body ground | Always | 10 kΩ or higher |
| L48-5 (E) - L114-16 (CO) | Always | Below 1 Ω |
| L48-5 (E) - Body ground | Always | 10 kΩ or higher |
| L48-8 (VR1) - L114-7 (VR1) | Always | Below 1 Ω |
| L48-8 (VR1) - Body ground | Always | 10 kΩ or higher |
| L48-7 (VR2) - L114-6 (VR2) | Always | Below 1 Ω |
| L48-7 (VR2) - Body ground | Always | 10 kΩ or higher |
| L49-1 (WF) - L114-4 (W) | Always | Below 1 Ω |
| L49-1 (WF) - Body ground | Always | 10 kΩ or higher |
| L49-2 (EW) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||