WIPER AND WASHER SYSTEM > Rain Sensor Circuit |

| 1.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - RAIN SENSOR) |
Disconnect the L114 windshield wiper relay assembly connector.
Disconnect the U11 rain sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L114-8 (SIG) - U11-4 (SIG) | Always | Below 1 Ω |
| U11-4 (SIG) - Body ground | Always | 10 kΩ or higher |
| L114-14 (PA1) - U11-3 (AUTO) | Always | Below 1 Ω |
| U11-3 (AUTO) - Body ground | Always | 10 kΩ or higher |
| L114-25 (E) - U11-1 (ES) | Always | Below 1 Ω |
| U11-1 (ES) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT WINDSHIELD WIPER RELAY ASSEMBLY |
![]() |
Reconnect the windshield wiper relay assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L114-8 (SIG) - L114-25 (E) | Power switch on (IG) | 11 to 14 V |
| *1 | Component with harness connected (to Windshield Wiper Relay Assembly) |
|
| ||||
| OK | |
| 3.INSPECT RAIN SENSOR |
![]() |
Reconnect the rain sensor connector.
Connect an oscilloscope to the automatic light control sensor connector.
Check for pulses.
| Tester Connection | Condition | Specified Condition |
| U11-3 (AUTO) - U11-1 (ES) | Power switch on (IG) | Pulse generation |
| *1 | Component with harness connected (Rain Sensor) |
|
| ||||
| OK | ||
| ||