Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER (for Power Seat)

FRONT SEAT CUSHION HEATER (for Power Seat) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY (SEPARATE TYPE FRONT SEAT CUSHION COVER)


    B229847
  1. Using hog ring pliers, install the front seat cushion heater assembly (separate type front seat cushion cover) to the separate type front seat cushion pad with 11 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



    B232926
  1. Using hog ring pliers, install 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD


  1. Engage each hook to install the separate type front seat cushion cover with pad to the front seat cushion spring sub-assembly as shown in the illustration.


    B312113



    B302509
  1. Engage the 2 hooks as shown in the illustration.



    B302511
  1. Engage the fastener to connect the side airbag wire harness.

  1. Connect the connector and engage the clamp to connect the seat heater wire harness.



    B299222
  1. Engage the 3 clamps to connect the seat heater wire harness.



    B299218
  1. Engage the 4 hooks.



    B302433
  1. Connect the rubber band.



3. INSTALL FRONT INNER SEAT CUSHION SHIELD


    B302431
  1. Engage the 5 claws and install the front inner seat cushion shield.



4. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY


    B299302E01
  1. Connect the 2 connectors.
    Text in Illustration 
    *1
    Clamp
    *2
    Hook

  1. Engage the clamp and hook as shown in the illustration.



    B312114
  1. Engage the guide and 4 claws as shown in the illustration.

  1. Engage the clip to install the front seat cushion shield assembly.



    B299212
  1. Engage the 6 clamps.

  1. Connect the 4 connectors.



5. INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD


    B302427
  1. Engage the 2 claws and clip.

  1. Engage the guide to install the front inner No. 1 seat cushion shield to the front seat cushion shield with the screw.



6. INSTALL FRONT SEAT INNER BELT ASSEMBLY


    B221556E01
  1. Install the front seat inner belt assembly with the nut.
    Text in Illustration 
    *1
    Protruding Part

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.

  1. Connect each connector.

  1. Engage each clamp.



7. INSTALL FRONT SEAT ASSEMBLY
(Click here)