Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

DTC    B157D    DAB Tuner Antenna Disconnected

for Preparation Click here


DESCRIPTION

This DTC is stored when a malfunction occurs in the digital audio broadcasting antenna assembly which is connected to the navigation ECU sub-assembly.

DTC No.
DTC Detection Condition
Trouble Area
B157D
The digital audio broadcasting antenna assembly is not connected.
  1. No. 2 Antenna cord sub-assembly
  2. No. 4 antenna cord sub-assembly
  3. No. 5 antenna cord sub-assembly
  4. Roof antenna pole sub-assembly
  5. Amplifier antenna assembly (for Roof)
  6. Navigation ECU sub-assembly

INSPECTION PROCEDURE

1.REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Replace the No. 2 antenna cord sub-assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

END 

2.INSPECT NO. 4 ANTENNA CORD SUB-ASSEMBLY
  1. Disconnect the No. 4 antenna cord sub-assembly.

  1. Measure the resistance of the No. 4 antenna cord sub-assembly to check for an open circuit in the No. 4 antenna cord sub-assembly.

    Standard Resistance:
    Below 1 Ω

  1. Measure the resistance between the No. 4 antenna cord sub-assembly and body ground to check for a short circuit in the No. 4 antenna cord sub-assembly.

    Standard Resistance:
    10 kΩ or higher



NG
REPLACE NO. 4 ANTENNA CORD SUB-ASSEMBLY (Click here)
OK


3.INSPECT NO. 5 ANTENNA CORD SUB-ASSEMBLY
  1. Disconnect the No. 5 antenna cord sub-assembly.

  1. Measure the resistance of the No. 5 antenna cord sub-assembly to check for an open circuit in the No. 5 antenna cord sub-assembly.

    Standard Resistance:
    Below 1 Ω

  1. Measure the resistance between the No. 5 antenna cord sub-assembly and body ground to check for a short circuit in the No. 5 antenna cord sub-assembly.

    Standard Resistance:
    10 kΩ or higher



NG
REPLACE NO. 5 ANTENNA CORD SUB-ASSEMBLY (Click here)
OK


4.REPLACE ROOF ANTENNA POLE SUB-ASSEMBLY
  1. Replace the roof antenna pole sub-assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 5
OK

END 

5.REPLACE AMPLIFIER ANTENNA ASSEMBLY (for Roof)
  1. Replace the amplifier antenna assembly (for Roof) (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)
OK

END