Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CRUISE CONTROL MAIN SWITCH


  1. for cruise control system:



    1. Measure the resistance according to the value(s) in the table below.


      E144930E12


      Text in Illustration 
      *1
      Component without harness connected
      (Cruise Control Main Switch)
      *2
      Main Switch
      *3
      Lever
      *4
      ON/OFF
      *5
      - SET
      *6
      + RES
      *7
      CANCEL
      -
      -

      Standard Resistance:

      Tester Connection
      Switch Condition
      Specified Condition
      1 - 3
      Main Switch off*1
      1 MΩ or higher
      Main Switch on
      Below 2.5 Ω
      + RES
      235 to 245 Ω
      - SET
      617 to 643 Ω
      CANCEL
      1509 to 1571 Ω

      *1: Lever is in the neutral position
      If the result is not as specified, replace the cruise control main switch.



  1. for dynamic radar cruise control system:



    1. Measure the resistance according to the value(s) in the table below.


      E107856E21


      Text in Illustration 
      *1
      Component without harness connected
      (Cruise Control Main Switch)
      *2
      ON/OFF
      *3
      CANCEL
      *4
      - SET
      *5
      + RES
      *6
      MODE

      Standard Resistance:

      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      1 - 3
      Main Switch off*1
      1 MΩ or higher
      1 - 3
      Main switch on
      Below 2.5 Ω
      1 - 2
      MODE
      Below 2.5 Ω
      1 - 3
      + RES
      235 to 245 Ω
      1 - 3
      - SET
      617 to 643 Ω
      1 - 3
      CANCEL
      1509 to 1571 Ω

      *1: Lever is in the neutral position
      If the result is not as specified, replace the cruise control main switch.