Home › Vehicle Exterior › WIPER / WASHER › RELAY (w/ Headlight Cleaner System)

RELAY (w/ Headlight Cleaner System) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER CONTROL RELAY


    E144468E38
  1. Disconnect the A44 headlight cleaner control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A44-3 (IG) - Body ground
    Power switch off
    Below 1 V
    Power switch on (IG)
    11 to 14 V
    A44-6 (PB) - Body ground
    Always
    11 to 14 V
    A44-2 (H) - Body ground
    Headlight cleaner switch off
    11 to 14 V
    Headlight cleaner switch on
    Below 1 V
    A44-5 (FRWA) - Body ground
    Front washer switch off
    11 to 14 V
    Front washer switch on
    Below 1 V

    If the result is not as specified, there is a malfunction in the wire harness.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A44-4 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Headlight Cleaner Control Relay)
    If the result is not as specified, there is a malfunction in the wire harness.