STOP LIGHT CONTROL RELAY > INSPECTION |
| 1. INSPECT STOP LIGHT CONTROL ECU ASSEMBLY |
![]() |
Disconnect the A28 stop light control ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A28-5 (STP) - Body ground | Brake pedal released | Below 1 V |
| Brake pedal depressed | 11 to 14 V | |
| A28-6 (+B) - Body ground | Always | 11 to 14 V |
| *1 | Front view of wire harness connector (to Stop Light Control ECU Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A28-8 (GND) - Body ground | Always | Below 1 Ω |
![]() |
Reconnect the A28 stop light control ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A28-1 (OUT) - Body ground | Brake pedal released | Below 1 V |
| Brake pedal depressed | 11 to 14 V |
| *1 | Component without harness connected (Stop Light Control ECU Assembly) |