Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT LICENSE PLATE LIGHT ASSEMBLY


    E136359E11
  1. Connect a positive (+) lead from the battery to terminal 2 and a negative (-) lead to terminal 1.

  1. Check that the license plate light comes on.

    OK:
    The light comes on.

    Text in Illustration 
    *1
    Component without harness connected
    (License Plate Light Assembly LH)
    If the result is not as specified, replace the bulb or license plate light socket and wire LH.