Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION CONTROL AND PANEL SUB-ASSEMBLY


    E190200E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    8 (F) - 5 (E)
    Hazard warning switch off
    10 kΩ or higher
    Hazard warning switch on
    Below 1 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Integration Control and Panel Sub-assembly)
    If the result is not as specified, replace the integration control and panel sub-assembly.