NAVIGATION SYSTEM (for DVD) > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - NO. 1 STEREO JACK ADAPTER) |
![]() |
Disconnect the L41 navigation receiver assembly connector.
![]() |
Disconnect the SJ No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L41-19 (AUXI) - SJ-4 (AUXO) | Always | Below 1 Ω |
| L41-18 (AGND) - SJ-5 (AGND) | Always | Below 1 Ω |
| L41-15 (ARI) - SJ-2 (ARO) | Always | Below 1 Ω |
| L41-17 (ALI) - SJ-1 (ALO) | Always | Below 1 Ω |
| L41-16 (ASGN) - SJ-3 (ASGN) | Always | Below 1 Ω |
| L41-19 (AUXI) - Body ground | Always | 10 kΩ or higher |
| L41-18 (AGND) - Body ground | Always | 10 kΩ or higher |
| L41-15 (ARI) - Body ground | Always | 10 kΩ or higher |
| L41-17 (ALI) - Body ground | Always | 10 kΩ or higher |
| L41-16 (ASGN) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Navigation Receiver Assembly) |
| *2 | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||