AUDIO AND VISUAL SYSTEM > Data Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the radio and display receiver assembly connector.
Disconnect the No. 1 stereo jack adapter assembly connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L153-2 (UDO-) - L124-2 (UDO-) | Always | Below 1 Ω |
| L153-3 (UDO+) - L124-3 (UDO+) | Always | Below 1 Ω |
| L153-5 (USG1) - L124-5 (UJSS) | Always | Below 1 Ω |
| L153-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| L153-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
| L153-5 (USG1) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||