NAVIGATION SYSTEM (for Navigation Receiver Type) > Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
![]() |
Disconnect the navigation ECU sub-assembly connector.
Disconnect the No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L131-2 (US1-) - L124-2 (UDO-) | Always | Below 1 Ω |
| L131-3 (US1+) - L124-3 (UDO+) | Always | Below 1 Ω |
| L131-5 (USG1) - L124-5 (UJSS) | Always | Below 1 Ω |
| L131-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| L131-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| L131-5 (USG1) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Navigation ECU Sub-assembly) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||