NAVIGATION SYSTEM (for Radio and Display Type) > Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L143-1 (MUTE) - Body ground | Power switch on (ACC), audio system playing → Changing modes | Above 3.5 V → Below 1 V |
| *a | Component with harness connected (Stereo Component Amplifier Assembly) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the radio and display receiver assembly connector.
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L149-20 (MUT2) - L143-1 (MUTE) | Always | Below 1 Ω |
| L149-20 (MUT2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL) |
Reconnect the stereo component amplifier assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L149-20 (MUT2) - Body ground | Power switch on (ACC), audio system is playing | Above 3.5 V |
| *a | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
|
| ||||
| OK | ||
| ||