Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

NAVIGATION SYSTEM (for Navigation Receiver Type) > Navigation Voice Circuit

for Preparation Click here


DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in the "Bluetooth" hands-free system is heard.
Using this circuit, the navigation ECU sub-assembly sends the signals to the stereo component amplifier assembly.

WIRING DIAGRAM


E230083E09


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the navigation ECU sub-assembly connector.

  1. Disconnect the stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Condition
    Specified condition
    L128-2 (RL+) - L143-15 (II1+)
    Always
    Below 1 Ω
    L128-6 (RL-) - L143-14 (II1-)
    Always
    Below 1 Ω
    L143-18 (SLD1) - Body ground
    Always
    10 kΩ or higher
    L128-2 (RL+) - Body ground
    Always
    10 kΩ or higher
    L128-6 (RL-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)