AIRBAG CUT-OFF SWITCH > INSPECTION |
| 1. INSPECT AIRBAG CUT OFF SWITCH |
Turn the power switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
![]() |
Disconnect the connector from the airbag cut off switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L117-2 (PMC+) - L117-1 (PMC-) | Cut off switch in ON | 360 to 440 Ω |
| L117-2 (PMC+) - L117-1 (PMC-) | Cut off switch in OFF | 90 to 110 Ω |
| *1 | Component without harness connected (Airbag Cut Off Switch) |