Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Rear Side)

WASHER NOZZLE (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR WASHER NOZZLE


    E189293
  1. Connect the washer hose.



    E189294
  1. Engage the 2 claws to install the rear washer nozzle.



2. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY


    B227896
  1. Engage the 4 clips and 4 claws to install the upper back door trim panel assembly.



3. INSPECT REAR WASHER NOZZLE


  1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the area shown in the illustration.



    E189308E01


    Standard Clearance 
    Area
    Measurement
    A
    48.7 mm (1.92 in.)

    HINT:
    If the result is not as specified, replace the malfunctioning rear washer nozzle.



4. ADJUST REAR WASHER NOZZLE


    E190123
  1. Using a screwdriver, adjust the direction of the rear washer nozzle.

    NOTICE:
    Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.

    HINT:
    Use a thin-bladed screwdriver with an approximately 1 mm (0.0394 in.) thick tip.