PARKING BRAKE PEDAL (for RHD) > INSTALLATION |
| 1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY |
![]() |
Install the parking brake control pedal assembly with the 2 bolts and nut.
![]() |
Connect the parking brake switch connector.
Engage the wire harness clamp.
![]() |
Using SST, install the bolt (A).
| *1 | Fulcrum Length |
Install the No. 1 parking brake cable assembly with the 4 bolts.
Engage the clamp.
![]() |
Temporarily install the lock nut.
| *1 | Lock Nut |
| 2. CONNECT NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY |
![]() |
Connect the No. 1 parking brake pull rod sub-assembly to the parking brake control pedal assembly as shown in the illustration.
| *1 | Turn |
| *2 | Hold |
| 3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY |
![]() |
Engage the 2 claws to install the No. 2 air duct sub-assembly.
| 4. INSTALL NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY |
![]() |
Install the No. 3 belt anchor reinforcement subassembly with the 4 bolts.
| 5. INSTALL NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY |
![]() |
Install the No. 2 belt anchor reinforcement subassembly with the 4 bolts.
| 6. INSTALL YAW RATE AND ACCELERATION SENSOR |
![]() |
Connect the yaw rate and acceleration sensor connector.
Install the yaw rate and acceleration sensor with the 2 bolts.
| 7. INSTALL FRONT SEAT ASSEMBLY LH |
| 8. INSTALL FRONT SEAT ASSEMBLY RH |
| 9. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY |
| 10. ADJUST PARKING BRAKE PEDAL TRAVEL |
Remove the No. 2 instrument panel under cover sub-assembly.
Completely release the parking brake pedal.
![]() |
Loosen the lock nut and the adjusting nut to completely release the parking brake cable.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
Turn the adjusting nut until the parking brake pedal travel is corrected to be within the specified range.
![]() |
Using a wrench or an equivalent tool, hold the adjusting nut and tighten the lock nut.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
Operate the parking brake pedal 3 to 4 times, and check the parking brake pedal travel.
Check whether the parking brake drags or not.
Install the No. 2 instrument panel under cover sub-assembly.
| 11. INSPECT BRAKE WARNING LIGHT |
When operating the parking brake pedal, check that the brake warning light illuminates.