Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL (for LHD)

PARKING BRAKE PEDAL (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE AIR CONDITIONING UNIT

HINT:
Refer to the instructions for Removal of the air conditioning unit (Click here).



2. REMOVE FRONT SEAT ASSEMBLY LH

HINT:
Refer to the instructions for Removal of the front seat assembly (Click here).



3. REMOVE FRONT SEAT ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



4. REMOVE NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY


    C206642
  1. Remove the 4 bolts and No. 2 belt anchor reinforcement sub-assembly.



5. REMOVE NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY


    C206643
  1. Remove the 4 bolts and No. 3 belt anchor reinforcement sub-assembly.



6. LOOSEN ADJUSTING NUT


    C209223E01
  1. Remove the lock nut and loosen the adjusting nut.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Adjusting Nut



7. SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    C206649E01
  1. Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.
    Text in Illustration 
    *1
    Turn
    *2
    Hold



8. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    C206646
  1. Remove the 5 bolts and nut, and separate the No. 1 parking brake cable assembly.

  1. Remove the clamp.



    C206647
  1. Disconnect the parking brake switch connector.

  1. Disengage the wire harness clamp.



    C206648
  1. Remove the bolt, 2 nuts and parking brake control pedal assembly.