Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL (for RHD)

PARKING BRAKE PEDAL (for RHD) > REMOVAL

for Preparation Click here



1. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

HINT:
This is symmetrical to the LHD model (Click here).



2. REMOVE FRONT SEAT ASSEMBLY LH

HINT:
Refer to the instructions for Removal of the front seat assembly (Click here).



3. REMOVE FRONT SEAT ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



4. REMOVE YAW RATE AND ACCELERATION SENSOR


    C208052
  1. Remove the 2 bolts and yaw rate and acceleration sensor.

  1. Disconnect the connector from the yaw rate and acceleration sensor.



5. REMOVE NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY


    C206642
  1. Remove the 4 bolts and No. 2 belt anchor reinforcement sub-assembly.



6. REMOVE NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY


    C206643
  1. Remove the 4 bolts and No. 3 belt anchor reinforcement sub-assembly.



7. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    C206680
  1. Disengage the 2 claws to remove the No. 2 air duct sub-assembly.



8. LOOSEN ADJUSTING NUT


    C209224E01
  1. Remove the lock nut and loosen the adjusting nut.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Adjusting Nut



9. SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    C206649E01
  1. Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.
    Text in Illustration 
    *1
    Turn
    *2
    Hold



10. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    C206661
  1. Remove the 5 bolts and separate the No. 1 parking brake cable assembly.

  1. Disengage the clamp.



    C206664
  1. Disconnect the parking brake switch connector.

  1. Disengage the wire harness clamp.



    C206665
  1. Remove the 2 bolts, nut and parking brake control pedal assembly.