FUEL PUMP > REMOVAL |
| 1. PRECAUTION (w/ Navigation System for HDD) |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 4. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 5. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 6. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 7. REMOVE REAR SEAT CUSHION ASSEMBLY |
![]() |
Disengage the 2 front hooks of the seat cushion from the vehicle body as shown in the illustration.
| *1 | 100 mm (3.94 in.) or less |
| *2 | Hook |
| *3 | Guide |
Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.
Repeat the above procedure for the other hook.
Disengage the 2 guides of the seat cushion from the seatback.
Remove the rear seat cushion assembly.
| 8. REMOVE REAR FLOOR SERVICE HOLE COVER |
![]() |
Remove the rear floor service hole cover.
![]() |
Disconnect the connector from the fuel suction tube assembly.
| 9. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Remove the tube joint clip, then pull the fuel tube joint out of the plug of the fuel suction tube assembly.
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | O-ring |
| 10. DISCONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY |
![]() |
Loosen the clip and disconnect the No. 1 fuel evaporation tube sub-assembly from the fuel suction tube assembly.
| 11. DISCONNECT NO. 1 CHARCOAL CANISTER OUTLET HOSE |
![]() |
Disconnect the No. 1 charcoal canister outlet hose from the fuel suction tube assembly.
| 12. DISCONNECT FUEL TANK EVAPORATION TUBE |
![]() |
Release the retainer and disconnect the fuel tank evaporation tube from the fuel suction tube assembly.
| *1 | Retainer |
| 13. REMOVE FUEL PUMP GAUGE RETAINER |
![]() |
Using a 6 mm socket hexagon wrench, set SST to the fuel pump gauge retainer.
![]() |
Using SST, loosen the fuel pump gauge retainer.
Remove the fuel pump gauge retainer while holding the fuel suction tube assembly by hand.
| 14. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |
![]() |
Remove the fuel suction tube assembly with pump and gauge from the fuel tank.
![]() |
Remove the gasket from the fuel tank.
| *1 | Gasket |