DTC P0AC0-123 Hybrid Battery Pack Current Sensor Circuit Range / Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0AC0-123 | When the battery current sensor is abnormal (1 or 2 trip detection) |
|
| 1.CHECK DTC OUTPUT (HV) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Read output DTCs (Click here).
| Result | Proceed to |
| Only DTC P0AC0-123 is output or DTC P0AC0-123 and DTCs other than those in the following table are output. | A |
| Any of the DTCs in the following table are output at the same time. | B |
| DTC No. | Relevant Diagnosis |
| P0A95-123 | High Voltage Fuse |
| P0ABF-123 | Hybrid Battery Pack Current Sensor Circuit |
| P0AC1-123 | Hybrid Battery Pack Current Sensor "A" Circuit Low |
| P0AC2-123 | Hybrid Battery Pack Current Sensor "A" Circuit High |
| P0AFC-123 | Hybrid Battery Pack Sensor Module |
| P0B3D-123, P0B42-123, P0B47-123, P0B4C-123, P0B51-123, P0B56-123, P0B5B-123, P0B60-123, P0B65-123, P0B6A-123, P0B6F-123, P0B74-123, P0B79-123, P0B7E-123, P0B83-123 | Hybrid Battery Voltage Sensor "A - O" Circuit Low |
Turn the power switch off.
Disconnect the intelligent tester from the DLC3.
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Data List / Battery block Vol -V01 to V14.
Check the voltage of each "Battery block Vol" of "Battery block Vol -V01 to V14" in the Data List with the power switch on (IG).

| Result | Proceed to |
| The change in voltage of any "Battery block Vol" is 0.3 V or more. | A |
| Other than above. | B |
|
| ||||
| A | ||
| ||