Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

DTC    C2176/76    Receiver Error

for Preparation Click here


DESCRIPTION

Tire pressure warning valve and transmitter signals are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves.

DTC No.
DTC Detection Condition
Trouble Area
C2176/76
Malfunction in the tire pressure warning ECU and receiver internal circuit
Tire pressure warning ECU and receiver

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.

1.CHECK DTC OUTPUT (C2176/76)
  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG) and check for DTCs (Click here).

    OK:
    DTC C2176/76 is not output.



NG
REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)
OK

END