Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)


    B223658
  1. Remove the 2 screws <D>.

  1. Disengage the claw and guide.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)


    B223634
  1. Remove the screw <D>.

  1. Disengage the 2 claws and guide.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.



3. REMOVE TIRE PRESSURE WARNING RESET SWITCH (for LHD)


    C298886
  1. Disengage the 2 claws to remove the tire pressure warning reset switch from the No. 1 instrument panel under cover sub-assembly.



4. REMOVE TIRE PRESSURE WARNING RESET SWITCH (for RHD)


    C298882
  1. Disengage the 2 claws to remove the tire pressure warning reset switch from the No. 1 instrument panel under cover sub-assembly.