Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the power steering system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK DTC AND FREEZE FRAME DATA*

      HINT:
      Refer to Clear DTCs (Click here).


    NEXT


    4.PROBLEM SYMPTOM CONFIRMATION

      Result:
      Result
      Proceed to
      Symptom does not occur.
      A
      Symptom occurs.
      B



    B.
    Go to step 6
    A


    5.SYMPTOM SIMULATION

      NEXT


      6.CHECK CAN COMMUNICATION SYSTEM*
      1. Check for DTCs (Click here).

        Result:
        Result
        Proceed to
        CAN system DTC is not output
        A
        CAN system DTC is output
        B

        HINT:
        1. If any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
        2. If communication to the power steering ECU cannot be established through the intelligent tester, inspect terminals CANH and CANL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.



      B.
      PROCEED TO CAN COMMUNICATION SYSTEM (Click here)
      A


      7.CHECK FOR DTC*
      1. Check for DTCs (Click here).

        HINT:
        Refer to Diagnostic Trouble Code Chart when any DTCs are output (Click here).

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      Go to step 9
      A


      8.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result:
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B



      B.
      Go to step 9
      A


      9.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Refer to Terminals of ECU (Click here).

      2. Refer to Data List / Active Test (Click here).


      NEXT


      10.REPAIR OR REPLACE

        NEXT


        11.CONFIRMATION TEST

          NEXT

          END