STEERING GEAR > INSPECTION |
| 1. INSPECT TIE ROD END SUB-ASSEMBLY LH |
![]() |
Secure the tie rod end sub-assembly LH in a vise.
Install the nut to the stud bolt.
Flip the ball joint back and forth 5 times.
Set a torque wrench to the nut, turn the ball joint continuously at a rate of 2 to 4 seconds per turn, and check the turning torque on the 5th turn.
| 2. INSPECT TIE ROD END SUB-ASSEMBLY RH |
| 3. INSPECT TOTAL PRELOAD |
![]() |
Install SST to the pinion shaft and turn it left and right 5 times or more.
Set a torque wrench to SST and turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.
| w/ EGR System | w/o EGR System |
| 0.7 to 1.1 N*m (7 to 11 kgf*cm, 6 to 9 in.*lbf) | 0.95 to 1.55 N*m (10 to 15 kgf*cm, 9 to 13 in.*lbf) |