DTC B2074 Driver Side Seat Belt Buckle Switch Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2074 | Open or short in front seat inner belt (buckle switch) circuit |
|


| 1.CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT RH - SEAT BELT CONTROL ECU) |
![]() |
Disconnect the front seat inner belt connector.
Disconnect the seat belt control ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Condition | Specified Condition |
| L3-4 (RBL+) - S22-5 (RBE+) | Always | Below 1 Ω |
| L3-3 (RBL-) - S22-4 (RBE-) | Always | Below 1 Ω |
| L3-4 (RBL+) or S22-5 (RBE-) - Body ground | Always | 10 kΩ or higher |
| L3-3 (RBL-) or S22-4 (RBE-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| L3-5 (LBL+) - R5-5 (LBE+) | Always | Below 1 Ω |
| L3-6 (LBL-) - R5-4 (LBE-) | Always | Below 1 Ω |
| L3-5 (LBL+) or R5-5 (LBE+) - Body ground | Always | 10 kΩ or higher |
| L3-6 (LBL-) or R5-4 (LBE-) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Front Seat Inner Belt) |
| *2 | Front view of wire harness connector (to Seat Belt Control ECU) |
| *3 | for RHD |
| *4 | for LHD |
Reconnect the seat belt control ECU connector.
Reconnect the front seat inner belt connector.
|
| ||||
| OK | |
| 2.CHECK SEAT BELT CONTROL ECU |
![]() |
Fasten the driver side seat belt.
Turn the power switch on (IG).
Using an oscilloscope, check the waveform of the seat belt control ECU between the connector terminals.
| Item | Contents |
| Terminal | L3-4 (RBL+) L3-3 (RBL-) L3-5 (LBL+) L3-6 (LBL-) |
| Tool setting | 2 V/DIV, 20 ms/DIV |
| Vehicle Condition | Power switch on (IG) |
| *1 | Seat Belt Control ECU |
|
| ||||
| OK | ||
| ||