Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR

COMPRESSOR > INSPECTION

for Preparation Click here



1. INSPECT COMPRESSOR WITH MOTOR ASSEMBLY

CAUTION:
  1. Because the compressor has a high-voltage circuit, wear insulated gloves and pull out the service plug grip to cut off the high-voltage circuit before inspection.
  2. Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.

NOTICE:
Do not start the engine with the service plug grip removed because it may cause a malfunction.



    E189800E02
  1. Disconnect the compressor with motor assembly connector.

  1. Using a megohmmeter, measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-1 (PE) - Body ground
    Always
    2 MΩ or higher
    E1-2 (PB) - Body ground
    Always
    2 MΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Compressor with motor assembly)
    If the resistance is not as specified, replace the compressor with motor assembly.