Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Power Switch Illumination Circuit

for Preparation Click here


DESCRIPTION

The illuminated entry system controls the power switch illumination.

WIRING DIAGRAM


E181483E06


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Smart Key / Active Test.

  1. Check that the the illumination operates.

    Smart Key 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Power/Engine SW Light
    Power switch illumination
    ON/OFF
    -

    OK:
    Power switch illumination comes on.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT POWER SWITCH


    E168984E01
  1. Remove the power switch (Click here).

  1. Connect a positive (+) lead from the battery to terminal 11 and a negative (-) lead to terminal 5.

  1. Check that the illumination comes on.

    OK:
    Power switch illumination comes on.

    Text in Illustration 
    *1
    Component without harness connected
    (Power Switch)



NG
REPLACE POWER SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (POWER SWITCH - CERTIFICATION ECU AND BODY GROUND)
  1. Disconnect the L62 certification ECU (smart key ECU assembly) connector.

  1. Disconnect the L43 power switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L43-11 (SWIL) - L62-11 (SWIL)
    Always
    Below 1 Ω
    L43-11 (SWIL) - Body ground
    Always
    10 kΩ or higher
    L43-5 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)