Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Rear Side)

WASHER NOZZLE (for Rear Side) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR WASHER NOZZLE


  1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the area shown in the illustration.



    E189308E01


    Standard Clearance 
    Area
    Measurement
    A
    48.7 mm (1.92 in.)

    HINT:
    If the result is not as specified, replace the malfunctioning rear washer nozzle.