Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter

for Preparation Click here


DESCRIPTION

The circuit is necessary for the Automatic Sound Levelizer (ASL) built into the radio receiver assembly.
Speed signals are received from the combination meter assembly (No. 3 meter circuit plate) and used for the ASL.
The ASL function automatically adjusts the sound volume in order to enable clear audio quality even when vehicle noise increases (as vehicle noise increases, the volume is turned up etc.).

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly (No. 3 meter circuit plate). The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the following diagram will not operate normally.


WIRING DIAGRAM


E188185E01


INSPECTION PROCEDURE

1.INSPECT COMBINATION METER ASSEMBLY (NO. 3 METER CIRCUIT PLATE (OUTPUT WAVEFORM))


    E159354E21
  1. Check the output waveform.

    1. Remove the combination meter assembly (No. 3 meter circuit plate) with the connector still connected.

    2. Connect an oscilloscope to terminal L27-7 (+S) and body ground.

    3. Turn the power switch on (IG).

    4. Turn the wheel slowly.

    5. Check the signal waveform according to the condition(s) in the table below.
      Item
      Condition
      Tool setting
      5 V/DIV., 20 ms./DIV.
      Vehicle condition
      Driving at approx. 20 km/h (12 mph)

      OK:
      The waveform is displayed as shown in the illustration.

      HINT:
      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

      Text in Illustration 
      *1
      Component with harness connected
      (Combination Meter Assembly (No. 3 Meter Circuit Plate))



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)


    E144311E15
  1. Disconnect the radio receiver assembly and combination meter assembly (No. 3 meter circuit plate) connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L50-3 (SPD) - L27-7 (+S)
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Radio Receiver Assembly)
    *2
    Front view of wire harness connector
    (to Combination Meter Assembly (No. 3 Meter Circuit Plate))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)