NAVIGATION SYSTEM (for DVD) > Navigation Receiver Assembly Power Source Circuit |

| 1.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the L120 navigation receiver assembly connector.
![]() |
Disconnect the L42 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below .
| Tester Connection | Condition | Specified Condition |
| L120-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L120-4 (B) - L120-7 (GND) | Power switch off | 11 to 14 V |
| L120-3 (ACC) - L120-7 (GND) | Power switch on (ACC) | 11 to 14 V |
| L42-2 (IG) - L120-7 (GND) | Power switch on (IG) | 11 to 14 V |
| *1 | Front view of wire harness connector (to Navigation Receiver Assembly) |
| *2 | Front view of wire harness connector (to Navigation Receiver Assembly) |
|
| ||||
| OK | ||
| ||