AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - AUXILIARY BATTERY, BODY GROUND) |
Disconnect the radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L146-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L146-4 (+B1) - L146-7 (GND1) | Power switch off | 11 to 14 V |
| L146-3 (ACC1) - L146-7 (GND1) | Power switch on (ACC) | 11 to 14 V |
| L149-1 (IG) - L146-7 (GND1) | Power switch on (IG) | 11 to 14 V |
|
| ||||
| OK | ||
| ||