EXHAUST MANIFOLD > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
| 2. REMOVE NO. 2 ENGINE UNDER COVER |
| 3. REMOVE FRONT NO. 3 ENGINE UNDER COVER |
![]() |
Remove the 4 clips and front No. 3 engine under cover.
| 4. REMOVE FRONT CENTER FLOOR BRACE |
![]() |
Remove the 4 bolts and front center floor brace.
| 5. DRAIN COOLANT (for Engine with Exhaust Heat Recirculation System) |
Loosen the radiator drain cock plug and drain the coolant.
Loosen the cylinder block drain cock plug.

| *1 | Reservoir Tank Cap | *2 | Cylinder Block Drain Cock Plug |
| *3 | Radiator Drain Cock Plug | *4 | Air Release Valve |
| 6. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ Exhaust Heat Recirculation System) |
![]() |
Disconnect the 3 clamps and oxygen sensor connector.
![]() |
Disconnect the 2 heater water hoses.
![]() |
Remove the 4 bolts and 4 compression springs.
Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.
| 7. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/o Exhaust Heat Recirculation System) |
![]() |
Remove the 4 bolts and 4 compression springs.
Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.
| 8. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR |
![]() |
Remove the 3 nuts and No. 1 floor heat insulator.
| 9. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 3 bolts and No. 1 exhaust manifold heat insulator.
| 10. REMOVE AIR FUEL RATIO SENSOR NO.2 |
![]() |
Disconnect the air fuel ratio sensor connector and clamp.
![]() |
Using SST, remove the air fuel ratio sensor.
| 11. REMOVE MANIFOLD STAY |
![]() |
Remove the 3 bolts and manifold stay.
| 12. REMOVE EXHAUST MANIFOLD |
![]() |
Remove the 7 nuts, exhaust manifold and 2 gaskets.
| 13. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 3 bolts and No. 2 exhaust manifold heat insulator.