Home › Engine / Hybrid System › 2ZR-FXE INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. REMOVE NO. 2 ENGINE UNDER COVER


3. REMOVE FRONT NO. 3 ENGINE UNDER COVER


    A212642
  1. Remove the 4 clips and front No. 3 engine under cover.



4. REMOVE FRONT CENTER FLOOR BRACE


    A212643
  1. Remove the 4 bolts and front center floor brace.



5. DRAIN COOLANT (for Engine with Exhaust Heat Recirculation System)

NOTICE:
Do not remove the reservoir tank cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and drain the coolant.


    A251110E01


    Text in Illustration 
    *1
    Reservoir Tank Cap
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the coolant in a container and dispose of it according to the local regulations.



6. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ Exhaust Heat Recirculation System)


    A212646
  1. Disconnect the 3 clamps and oxygen sensor connector.



    A212644
  1. Disconnect the 2 heater water hoses.



    A215918
  1. Remove the 4 bolts and 4 compression springs.

  1. Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.



7. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/o Exhaust Heat Recirculation System)


    A215918
  1. Remove the 4 bolts and 4 compression springs.

  1. Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.



8. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR


    A212647
  1. Remove the 3 nuts and No. 1 floor heat insulator.



9. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A212648
  1. Remove the 3 bolts and No. 1 exhaust manifold heat insulator.



10. REMOVE AIR FUEL RATIO SENSOR NO.2


    A212298
  1. Disconnect the air fuel ratio sensor connector and clamp.



    A216699E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010  



11. REMOVE MANIFOLD STAY


    A212649
  1. Remove the 3 bolts and manifold stay.



12. REMOVE EXHAUST MANIFOLD


    A212650
  1. Remove the 7 nuts, exhaust manifold and 2 gaskets.



13. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A212651
  1. Remove the 3 bolts and No. 2 exhaust manifold heat insulator.