SLIDING ROOF SYSTEM > OPERATION CHECK |
| CHECK AUTO OPEN OPERATION |
Turn the power switch on (IG).
When the roof glass is fully closed, press the OPEN switch for 0.3 seconds or more. Check that the roof glass automatically tilts up until it is fully tilted upward.
When the roof glass is fully tilted upward, press the OPEN switch again for 0.3 seconds or more. Check that the roof glass automatically slides until it is comfort stop position.
When the roof glass is comfort stop position, press the OPEN switch again for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully open.
When the auto operation is operating, check that pressing any sliding roof switch stops the roof glass operation.
| CHECK SLIDING ROOF OPERATION AFTER POWER SWITCH IS TURNED OFF |
Turn the power switch from on (IG) to off, and check that the sliding roof can be operated. Then open the front door once, and check that the sliding roof cannot be operated.
Turn the power switch from on (IG) to off and wait for approximately 45 seconds. Check that the sliding roof cannot be operated.
Operate the auto open operation (tilt up or slide open) with the driver or front passenger side door open. While the roof glass is in motion, turn the power switch off. Check that the roof glass stops immediately.
| CHECK JAM PROTECTION FUNCTION |
When the slide close function is operating and an object is caught between the vehicle body and glass, check that the roof glass opens a distance of 218 mm (8.58 in.) from the point of contact with the object, or opens fully if an opening distance of 218 mm (8.58 in.) is not available.
When the tilt down function is operating, and an object is caught between the vehicle body and the roof glass, check that the sliding roof tilts up fully.
| CHECK SLIDING ROOF OPEN WARNING |
Open the sliding roof by using the sliding roof switch.
When the power switch is turned from on (IG) to off and the driver door is opened with the key is in the vehicle, check that the warning buzzer in the combination meter assembly sounds once.